OpenCores
no use no use 1/1 no use no use
Requesting Guidance for implementig network protocols in SOC
by sureshee on Oct 2, 2010
sureshee
Posts: 1
Joined: Sep 14, 2010
Last seen: May 31, 2011
Hi this is suresh, I m new to SOC ,i would like to do my project with SOC,i request you to help me on this


Abstract: a fully customized mixed-signal silicon chip that has most of the attributes required for use in a wearable or implantable BSN. Intellectual-property blocks include low-power analog sensor interface for temperature and pH, a data multiplexing and conversion module, a digital platform based around an 8-bit microcontroller, data encoding for spread-spectrum wireless transmission, and a RF section requiring very few off-chip components.


This is my base paper abstract, I need to know whether is it possible to use Ethernet at the transmitting section instead of RF section, so that i can send my data remotely to any other system which is actually located at some other place. Then is it possible to implement in ALTERA DE2 board.

Or is it possible to use Network On Chip concept, because it already have a provision of IPCore for network protocols, so that i can directly write code for that IP core to enable the protocols and transmit my data to the remote site.Is it possible to implement this NOC concept in ALTERA DE2 board.

I have attached my base paper for reference.

I request some one to reply for this post,so that it would be helpful for me to proceed further in this regard.

Thanks for Support
Regards
P.Suresh
sureshee@gmail.com
no use no use 1/1 no use no use
© copyright 1999-2025 OpenCores.org, equivalent to Oliscience, all rights reserved. OpenCores®, registered trademark.